Shipping And Storage; Care; Plastic Parts - Vermeiren Albatros Manual De Instrucciones

4.3

Shipping and storage

The shipping and storage of the patient hoist shall be according following instructions:
Store in a dry place (between + 5°C and + 41°C / 41°F and 105,8°F).
The relative humidity should be between 30% and 70%.
Check cables are not being crushed and to prevent kinks.
Provide sufficient covering or packaging to protect the patient hoist from rust and
foreign bodies. (e.g. salt water, sea air, sand, dust).
Store all removed parts together in one place (or mark them if necessary) to avoid
mixing up with other products when re-assembling (e.g. the charger).
Components must be stored without being subjected to strains (Don't put too heavy
parts on the patient hoist, not clamping between something, ...).
4.4

Care

Your lift will also require regular care if you want it to remain visually attractive. Please take
note of the following tips:
4.4.1 Covers
The cleaning of the cover shall be according:
 Clean covers with a cloth moistened with hot water. Be aware that you don't
soak the cover.
 Use a mild commercial detergent for removing stubborn dirt.
 Stains can be removed by using a sponge or a soft brush.
 Do not use strong cleaning liquids like solvents, nor use hard brushes.
 Never clean with steam and/or pressure washers.

4.4.2 Plastic parts

Clean plastic parts of your patient hoist with commercial plastic cleaners. Read the specific
product information and only use a soft brush or soft sponge.
4.4.3 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coat is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes
and cloths. Ensure that no wetness gets into the tubes.
Page 19
EN
Albatros
2010-12