SEVERIN KA 5155 Instrucciones De Uso página 12

Pad holder
To prepare coffee, a pad must be placed
inside the pad holder. When positioning the
pad, take care to place it right in the centre
of the holder. This ensures that the pad's
paper rim is not caught underneath the seal
when the lid is closed. If a pad is not equally
thick on all sides, the pad should be inserted
with the thicker part facing down. Do not
use any pads other than the round soft
coffee-pads commercially available.
Do not fill the pad holder with ground
coffee.
Fit the pad holder in the coffee outlet and
lock it by turning clockwise. To remove the
pad holder again, turn anti-clockwise.
Possible discolouring of the pad holder is
production-related, and is not in any way
detrimental to its quality or function.
Drip tray and drainer
Ensure that the drip tray and drainer are
correctly fitted before each use.
Drip tray
The drip tray can be removed by pulling it
out from the front. To replace the tray,
simply slide it back into place.
Drainer:
When inserting the drainer, ensure that
both the arresting hooks on the housing
properly engage in the two corresponding
openings on the rear part of the drainer.
Then push the drainer down so that the two
locating pins on the underside of the
drainer slide home into the corresponding
openings in the housing. When removing
the drainer, slightly lift up the front part
and pull it out from the appliance.
Coffee preparation
- Fill the water container up to its
maximum-level mark with fresh, clean
water.
- Insert the plug into a suitable wall
outlet.
- Fit the pad holder into the coffee outlet
and lock it by turning clockwise.
- Place the pad right in the centre of the
pad holder.
- Push the locking ring up.
- Slide the coffee outlet with the loaded
pad holder all the way into the
corresponding guide track on the
appliance.
- Push the locking ring down to close the
appliance properly.
- Place a cup of around 140 ml capacity
below the coffee outlet.
- Press the start button. The brewing
cycle starts and is indicated by the slow-
flashing light.
- Once pre-heating is complete, the coffee
is released straight into the cup. After
brewing, always wait until the
subsequent pressure-release phase
(indicated by the slow-flashing light) has
completely finished.
- Remove the cup from below the coffee
outlet.
- Push the locking ring up.
- Caution: the coffee outlet and the
inserts as well as the coffee pad are very
hot after brewing;
only the handle of the coffee outlet must
be used when it is removed from the
appliance Remove and dispose of the
used pad.
●
For reasons of hygiene, coffee pads
should be removed immediately after
each brewing cycle.
●
The brewing cycle can be interrupted at
any time by pressing the start button
again.
General care and cleaning
●
Before cleaning the appliance, ensure it
is disconnected from the power supply
and has cooled down completely.
●
To avoid the risk of electric shock, do
not clean the appliance with water and
do not immerse it in water.
●
Do not use abrasives or harsh cleaning
12
to prevent burns,