Checking And Replacing The Wear Guard - Stihl FBD-KM Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Removing the Blade
5
6
7
4
3
Insert stop pin (2) – see "Special
N
Accessories" – into hole (3) as far
as stop to block the shaft.
Fit the combination wrench (5) on
N
the screw (6).
Loosen the screw clockwise (left-
N
hand thread) and take it out.
Remove the thrust washer (7).
N
Remove and replace the blade (8).
N
FBD-KM
Mounting the Blade
8
2
Position the blade (8) on the thrust
N
plate (4).
WARNING
Collar (see arrow) of thrust plate must
engage the blade's mounting hole.
Place thrust washer (7), raised side
N
facing up, on the shaft (9) and block
the shaft.
Fit screw (6) on the shaft
N
counterclockwise (left-hand thread)
and tighten it down firmly.
Checking and Replacing the
Wear Guard
Checking the wear guard
6
8
7
9
4
N
N
NOTICE
The gearbox may be seriously damaged
if you do not replace the wear guard in
good time.
1
2
Check the wear guard (1) for
damage before starting the power
tool.
The wear guard must be replaced
as soon as the gearbox (2) (arrow)
becomes visible.
English
15

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido