Defiant DF-5928-WH Guía Para El Uso Y Cuidado página 11

Troubleshooting (continued)
Problem
The lights stay on continuously.
The lights flash on and off.
The lights flash once then stay
off in manual mode.
Possible Cause
The motion sensor may be picking up a
heat source, such as an air vent, dryer
vent, or brightly painted, heat-reflective
surface.
The motion sensor is in manual mode.
The light fixture is wired through a
dimmer or timer.
The light fixture is on the same circuit
as a motor, transformer, or fluorescent
bulb.
Heat or light from the bulbs may be
turning the motion sensor on and off.
Heat is being reflected from other
objects and may be turning the motion
sensor on and off.
The motion sensor is in "TEST" mode
and warming up.
The motion sensor is detecting light
from the lamp heads.
11
Solution
Please contact 1-866-308-3976 for further assistance.
Decrease the "SENS"
setting or reposition the
motion sensor.
Switch the motion sensor
to auto. See Using manual
mode on page 9.
Do not use a dimmer or
timer to control the light
fixture. Replace the dimmer
or timer with a standard on/
off wall switch.
Install the light fixture on
a circuit without motors,
transformers, or fluorescent
bulbs.
Reposition the lamp heads
away from the motion
sensor.
Decrease the "SENS"
setting or reposition the
motion sensor.
While in "TEST" mode,
the light only stays on for
8 seconds. Set the "ON-
TIME" switch to 1, 5, or 20
minutes.
Reposition the lamp heads
to keep the area below the
motion sensor relatively
dark.
HOMEDEPOT.COM