Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the Battery
Your timer requires a CR2032 Lithium battery .
• The battery will maintain your program in case of
an AC power loss .
• Battery should last approximately one year .
• Open by sliding the battery tray out to the right .
• Insert one CR2032 battery into the compartment
with the + side up .
• Slide the battery tray back into place .
1 2 3 4
24VAC
SENSOR COM
Figure 6:
Connecting a
Rain Sensor
A weak or missing battery can cause the time, date,
and program to be erased after a power failure . If
this happens, you will need to install a fully charged
battery and reprogram the timer .
Tip: Replace battery every year, to avoid loss of
programming.
Note: A battery alone will not operate the valves in your
sprinkling system. The sprinkler timer transformer must
be connected to an AC line voltage source.
BATTERY WARNING: Chemical Burn Hazard . Keep
batteries away from children .
See page 15 for additional information .
To Remove
Figure 7:
Battery Compartment
12
Publicidad
