Publicidad
Idiomas disponibles
Idiomas disponibles
Section 2:
Installation
Required Tools
• Phillips Screwdriver
• Wire Strippers
1. Select a Location
When choosing a location for your timer, consider the
following:
• Choose a location near an electrical outlet .
• Ensure operating temperatures are not below 32° or
above 158° Fahrenheit (below 0° Celsius or above 70°
Celsius) .
• Locate the timer where there is easy access to sprinkler
wire (from valves) .
2. Mount the Timer
• Use the mounting template (included) to mark the
mounting screw location on the wall . See figure 1
• Install a No . 8 screw into wall in the upper template
location . Leave the screw head protruding 1/8" (3 mm)
from wall . Use expanding anchors (included) in plaster
or masonry, if necessary, for a secure hold .
• Slip the timer over protruding screw (using keyhole slot
in back of timer) . See figure 2
• Drive a No . 8 screw through one of the two pre-formed
holes located in lower corners of the cabinet . See figure 2
Figure 1: Use Mounting Template (included)
Keyhole
Pre-formed
mounting holes
Figure 2: Hang timer on screw using keyhole
1/8" (3 mm)
No. 8 Screw
Wall
4
Publicidad
