en Cleaning and servicing
Press the two locking catches on
2.
the bristle ring.
Push the bristle ring down and
3.
lock it in place.
→ Fig.
17
a The Multi-Use-Brush is ready to
use.
Vacuum using the Multi-Use-Brush.
4.
→ "Starting vacuuming", Page 16
→ "Stopping vacuuming", Page 17
Press the two locking catches on
5.
the bristle ring.
Push the bristle ring upwards and
6.
lock it in place.
→ Fig.
17
Push the floor tool or the tube onto
7.
the Multi-Use-Brush.
Press the release button and re-
8.
move the Multi-Use-Brush to re-
move.
→ Fig.
18
Starting emergency mode
If the Remote-Power-Control handle
does not work, you can vacuum in
emergency mode.
Requirement: The appliance is in
standby mode.
→ "Switching on the appliance",
Page 16
Press
.
1.
a The status display goes out and
quickly flashes white three times
after a short time.
Press
while the status display is
2.
flashing.
a The appliance starts in turbo
mode.
Stopping emergency mode
Note: After vacuuming, check the Re-
mote-Power-Control handle.
→ "Troubleshooting", Page 22
18
Press
.
▶
a The status display goes out and
quickly flashes white three times
after a short time.
Removing the appliance
Disconnect the connection
1.
between the floor nozzle and the
telescopic tube.
→ Fig.
19
Disconnect the connection
2.
between the telescopic tube and
the handle.
→ Fig.
20
Press the two locking catches to-
3.
gether and pull the hose out of the
appliance.
→ Fig.
21
Cleaning and servicing
Cleaning and servicing
To keep your appliance working effi-
ciently for a long time, it is important
to clean and maintain it carefully.
Cleaning products
Only use suitable cleaning products.
ATTENTION!
Using unsuitable cleaning products
or incorrect cleaning may damage
the appliance.
Do not use harsh or abrasive de-
▶
tergents.
Do not use cleaning products with
▶
a high alcohol content.
Do not use hard scouring pads or
▶
cleaning sponges.
Wash sponge cloths thoroughly
▶
before use.