RIDGID R4210 Manual Del Operador página 33

OPERATION
ROUGH CUTTING A DADO
See Figures 44 - 46.
Using a wood chisel and the depth control knob, it is pos-
sible to make a rough dado cut. Always make a practice cut
on scrap wood.
To use the depth control knob:
 Unplug the saw.
 Rotate the depth stop outward.
 Loosen the lock nut.
 With the depth control knob touching the depth stop,
adjust the depth control knob by turning the knob until
the desired depth of cut is attained.
 Tighten the lock nut.
 A wooden spacer must be placed between the workpiece
and the fence to create a distance of 3-1/2 inches
between the workpiece and the fence for a consistent
depth of cut in the workpiece. Use the work clamp to
clamp the spacer and another suitable clamp to clamp
the workpiece. Make the slide cut at the desired depth.
 Rotate the depth stop inward for normal through cuts.
NOTE: The depth stop must be pushed in before locking/
unlocking the saw arm.
To make the cut:
 Unlock the slide lock knob.
 Pull out the head lock pin and lift saw arm to its full height.
 With the saw off, pull the saw arm forward. Turn the saw
on (let blade reach maximum speed), then push the blade
down on top of the workpiece then back toward the rear
of the saw to make a cut.
 Cut two outside grooves in the workpiece.
 Using a wood chisel, remove the material between the
two outside grooves.
DEPTH CONTROL KNOB
LOCK
NUT
DEPTH
STOP
WORK
CLAMP
C CLAMP
USE A CHISEL TO CUT
OUT THE MIDDLE
33 - English
WORKPIECE
CUT THESE GROOVES
WITH SAW
WORKPIECE
Fig. 44
SPACER
Fig. 45
Fig. 46