Craftsman ZTS 6000 Manual Del Operador página 32

MOWER DECK LEVELING
ADJUSTMENTS
WARNING
Before adjusting the mower, turn the mower
blades OFF, turn the ignition switch OFF, remove
the key, and allow all moving parts to stop.
Disconnect the spark plug wire and fasten it away
from the spark plug.
Side to Side Leveling
If the cut is uneven, the mower may need leveling.
Unequal or improper tire pressure may also cause an
uneven cut. See CHECK TIRE PRESSURE.
1. With the mower installed, place the rider on a
smooth, level surface such as a concrete floor. Turn
the front wheels straight forward. Turn the engine off,
set the ground speed control levers to PARK, set the
parking brake lever to ENGAGE, and wait for all mov-
ing parts to stop.
2. Check for bent blades and replace if necessary.
3. Check the tire pressures. See CHECK TIRE PRES-
SURE.
4. Set the cutting height to mid position. Arrange the
mower blades so that they are pointing from side-to-
side (see Figure 37).
5. Measure the distance between the tips of the outside
blades and the ground (Figures 37 & 38). If there is
more than 1/8" (3 mm) difference between the meas-
urements on each side, proceed to step 6. If the dif-
ference is 1/8" (3 mm) or less, proceed to Front To
Back Leveling.
6. Side-to-side leveling is accomplished using the
threaded rods (A, Figure 39) and trunnion (B) on the
right and left rear sides of the mower deck. Loosen
the jam nuts (C) and adjust the nuts up or down to
adjust the mower level. When complete, tighten the
jam nuts against the trunnion to lock the adjustment
in place.
Figure 37. Orient Blades Side-to-Side
A
B
C
Figure 38. Measure Blade Tips to Ground
A. Mower Deck
B. Blade Tip
C. Level Ground
A
C
Figure 39. Side-to-Side Adjustment
A. Threaded Rod
B. Trunnion
C. Jam Nuts
32
B