Cleaning The Shaver - Panasonic ES‑LV67 Instrucciones De Operación

Trimming sideburns

Cleaning the shaver

We recommend cleaning the shaver after each use.
Cleaning with water
• Turn the shaver off and disconnect the AC adaptor.
1
Apply some hand soap and
some water to the system
outer foil�
2
Press for more than
2 seconds to activate the sonic
vibration cleaning mode�
• Splashing of foam is suppressed.
• The battery capacity lamps blink
in order.
• After about 20 seconds, it will be
automatically turned off, or you can turn it off by
pressing the power switch.
ES-LV67_US.indb 15
Pre‑shave of long beards
3
Remove the outer foil
section and clean with
running water�
• See page 16 for removing the
outer foil section.
• Splashing is reduced by rinsing the shaver in sonic
vibration cleaning mode.
• After rinsing with water, shake the shaver up and
down for a few times to remove excess moisture and
then wipe off any drops of water with a dry cloth.
4
Dry the outer foil section,
the shaver, and the
trimmer completely�
• Allow the shaver to dry in the
shade, avoid direct sunlight.
5
Lubricate the shaver�
It will keep the movement of the
blade smooth and maintain a
comfort shave.
1. Apply one drop of oil to each of
the system outer foils.
2. Raise the trimmer and apply a drop of oil.
3. Switch the shaver on, and run it for approximately
five seconds.
4. Switch off the shaver, and wipe off any excess oil
from the system outer foil with a soft cloth.
Notes
• Be careful not to hit the main body on the sink or any
other object while draining the water. Failure to do so
may cause malfunction.
15
2019/06/03 19:20:13