Options - Seat - Sunrise Medical Breezy RelaX2 Manual De Usuario

When fastened check space
between the lap belt and user, when
correctly adjusted it should not be
possible to insert more than the flat
of the hand between the lap belt and
the user. (Fig. 29)
Generally the Lap Belt should be
fixed so that the straps sit at an angle
of approximately 45°, and when
correctly adjusted should not allow
user to slip down in the seat.
(Fig. 30)
to fasten buckle:
Firmly push male buckle into
female buckle.
adVice to client
danger!
• Do not rely on the lap belt only when the wheelchair and occupant
are transported in a vehicle, use the separate occupant lap and
diagonal restraints provided in the vehicle.
• Before use we recommend that the lap belt be checked to ensure
that it is adjusted correctly, free from any obstruction or adverse
wear and that the buckle engages securely.
• Failure to make sure that the lap belt is secure and adjusted prior
to use could cause serious injury to the user. e.g. too loose a
strap may allow the user to slip down in the chair and risk
suffocation.
Maintenance:
Check lap belt and securing components at regular intervals for any
sign of fraying or damage. Replace if necessary. Clean the lap belt
with warm soapy water and allow it to dry.
danger!
The lap belt should be adjusted to suit the end user as detailed
above Sunrise Medical also recommend that the length and fit of
the belt is checked on a regular basis to reduce the risk of the end
user inadvertently re-adjusting the belt to an excessive length.
If in doubt about the use and operation of the seat belt then ask
your healthcare professional, wheelchair dealer, carer or attendant
for assistance.
16
RelaX
2
Fig. 29
Fig. 30
to release belt:
press exposed sides of male
buckle and push towards
centre / push the press button
of the female buckle whilst
gently pull ing apart.

options - seat

coMFort seat (Fig. 31).
The comfort seat is an
anatomically shaped cushion
and offers comfortable seating
over a long period of time.
The cushion is held by Velcro
and can also be removed. The
cover can be washed (see the
instructions on the cushion).
seat depth (Fig. 32).
After loosening (a 360° turn) the
screws (1), you can set the seat
depth to the desired position.
Then tighten the screws again
(see page 6 for torque).
caution!
the maximum seat depth (see
marking and endstop) must
not be exceeded.
seat Width adJustMent
You can extend the width of the seat of your wheelchair by
removing the inner pads or add spacers (see option side guard)
adJustable seat
angle
(0°-25° / -3 -22°)
Before operation please
remove the locking pin, (1)
(Fig.33).
By pulling the lever (2) the seat
is released and can be put into
the desired position, (Fig.34).
When you let go, the seat is
automatically fixed in the new
position.
danger!
• Never adjust the seat angle if
the wheelchair is on a slope.
• The angle-adjustable seat
may only be used with anti-tip
tubes.
Warning!
there is a danger of trapping
your fingers when you adjusting the seat.
caution!
to ensure the correct function of the cables, these must never
be taut.
Fig. 31
1
1
Fig. 32
Fig. 33
2
1
Fig. 34
1