Brandt BFU662LNW Guia De Instalacion página 37

11. Unscrew bolts 23, fixing bottom
brackets 13 and 14 and take off
the brackets (pic. 8). Fix the bottom
plate 5 in places of brackets using
the same bolts. Screw the bolts into
the top brackets fixing holes.
12. Remove the protective film from the
top strip 2 (pic. 9). Attach the top
strip on both appliances. Start with
sticking the bent part at the front,
then continuing towards the back of
the appliances.
13. Insert front strip 1 to the gap
between fridge and freezer: slowly
push it with narrow side into the gap
between both appliances starting
from the top (pic. 9).
14. Keeping the
appliances open, place bottom cover
3 on bottom brackets 15 and 16,
fixing it with two bolts 7 (pic. 9).
Insert the bolts into the threaded
holes of brackets 15 and
16 and screw them in using a
wrench No. 10, applying downward
pressure with your finger.
Door position
planes A or C of the appliances are
not level
If the upper corner(s) of one (or both)
appliance(s) is somewhat lower than the
appliance body's plane A or the glass of
the doors do not comprise a single plane
C, adjust the bottom or top brackets:
1. Start by adjusting the bottom brackets:
- Remove outer legs 10;
- Relax the bolts that fasten bottom
brackets 15 and 16 and push the
brackets: refrigerator bracket 15 – to
the right, freezer bracket 16 – to the
left.
- If the upper inner corner of the door(s)
is (are) higher, adjust the brackets in the reverse manner:
refrigerator bracket 15 – to the left, freezer bracket 16 – to
the right.
2. If you are unable to level the appliances by adjusting the
bottom brackets, try adjusting the top brackets:
- Remove cover 26; Relax bolts 25;
- Adjust the position of top brackets 24.
Note. The picture shows top bracket 24 of the refrigerator.
The top bracket of the freezer is identical, but the bolts are at
the bottom.
doors of both
adjustment when

9
