Optional Accessories; Applications; Before Operation; Working Environment - Hitachi Koki N 3804AB3 Instrucciones Y Manual De Seguridad

OPTIONAL ACCESSORIES ... sold separately
Pneumatic Tool Lubricant
.8 oz. (25 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE:
Accessories are subject to change without any
obligation on the part of HITACHI.

APPLICATIONS

Making cases for furniture
Creating walls and other areas in mobile homes.
Making doors and windows for home
construction.

BEFORE OPERATION

Read section titled "SAFETY" (pages 4 – 6).
Make sure of the following before operation.

WORKING ENVIRONMENT

WARNING
No flammable gas, liquid or other
flammable objects at worksite.
Clear the area of children or
unauthorized personnel.

AIR SUPPLY

DANGER
WARNING
Never connect Stapler to pressure
which potentially exceeds 200 psi (13.7
bar 14 kgf/cm
Never use non relieving coupler on
Stapler.
1. Power source
Use only clean, dry, regulated compressed air as
a power source for this Stapler.
Air compressors used to supply compressed air
to this Stapler must comply with the requirements
of the latest version of ANSI Standard B 19.3
"Safety Standard For Compressors For Process
Industries."
(Code No.877153)
(Code No.874042)
(Code No.876212)
lNEVER use oxygen or
other bottled gases.
Explosion may occur.
).
2
Moisture or oil in the air compressor may
accelerate wear and corrosion in the Stapler.
Drain daily.
2. Filter-Regulator-Lubricator
Use a regulator with a pressure range of 0 – 120
psi (0 – 8.3 bar 0 – 8.5 kgf/cm
Filter-regulator-lubricator units supply an optimum
condition for the Stapler and extend the Stapler
life. These units should always be used.
Filter .............. The filter removes moisture and dirt
mixed in compressed air.
Drain daily unless fitted with an
automatic drain.
Keep the filter clean by regular
maintenance.
Regulator ...... The regulator controls the operating
pressure for safe operation of the
Stapler.
Inspect the regulator before
operation to be sure it operates
properly.
Lubricator ..... The lubricator supplies an oil mist
to the Stapler.
Inspect the lubricator before
operation to be sure the supply of
lubricant is adequate.
Use Hitachi pneumatic tool
lubricant.
Stapler
Side
Lubricator
3. Air hose
Air hose must have a minimum working pressure
rating of 150 psi (10.4 bar 10.6 kgf/cm
the maximum pressure produced in the system,
whichever is higher.
4. Air consumption
Using the Air consumption table and the Air
compressor size formula, find a correct compressor
size.
English
).
2
Regulator
Compressor
Side
Filter
) or 150% of
2
9