Single-Post Height Adjustable Armrests; Cantilever Armrests - Sunrise Medical Quickie QM-710 Manual De Instrucciones

Q M- 7 10/7 15HD/ 72 0
K. SINGLE POST HEIGHT-ADJUSTABLE ARMRESTS
1. Adjusting armrest receiver (forwards or backwards)
a. Loosen the 3 bolts (A) on the receiver clamp.
b. You can move the armrest and receiver forwards or backwards for a universal fit.
c. Tighten the hardware when adjustment is complete(A).
2. Adjusting Armrest Receiver Fit (tighten or loosen fit)
To tighten or loosen the fit of the outer armpost in the receiver:
a. Loosen the four bolts (B) on both sides of the receiver.
b. With the armrest in the receiver, squeeze the receiver to achieve the desired fit.
c. Continue the pressure on the receiver and tighten the four bolts.
3. Adjusting Inner Armpost Fit
a. Two set screws(C) are installed in the outer armpost.
b. Turn the set screws in or out until the desired fit is achieved.
L. CANTILEVER ARMRESTS
1. Adjusting Armrest Pad (forwards or backwards)
a. Loosen the 2 bolts (D) on the armrest pad bracket.
b. You can move the armrest and receiver forwards or backwards for a universal fit.
c. Tighten the hardware when adjustment is complete.
2. Adjusting Armrest Angle or levelling the armrest after height adjustment.
a. Loosen the pivot bolt (E) on the armrest angle bracket.
b. Remove the Socket head screw and hardware. (F)
c. Adjust the angle of the armrest and joystick and re-insert the hardware thru the
adjusted hole.
d. Tighten all hardware when adjustments are complete.
3. Adjusting Armrest Height (within factory limits)
a. Locate the height adjustment screw (G) at the bottom of the cantilever arm and
adjust the height by using a 5mm hex key and turning the screw either clockwise
(more height), or counter-clockwise (less height).
b. Do not loosen the screw to the point where it will fall out of the armrest. If this hap-
pens simply re-thread the screw into the armrest until it starts to height adjust the
armrest again.
c. When you reach desired height remember to level the armrest using screws (E) and
(F) as shown in step 2 above.
NOTE– The cantilever armrest has about 2" of adjustment set from the factory. In most cases the
external height adjustment will be all that is necessary for a proper fit
MK-100158 Rev. F
56 57
(optional)
XI. DEALER SERVICE AND ADJUSTMENT
54 55
(optional)
G
28
C
E
F
E
54
A
B
55
56
D
F
57