Accessories - RIDGID R4512 Manual Del Operador

MAINTENANCE
CLEANING THE DUST CHUTE
Clean the dust chute periodically to remove sawdust.
 Using a 4 mm hex key, remove the screws that secure
the back panel.
 Inspect the dust chute and attached dust collection
devices to clear away sawdust or other debris.
 Replace the back panel.
TO REMOVE AND CHANGE BELT
See Figure 80.
 Lower the blade by unlocking the height adjusting
handwheel and turning it counterclockwise.
 Using a 4 mm hex key, remove the screws that secure
the back panel.
 With a 6 mm hex key, loosen the bolt above and to the
right of the belt.
 Pull the belt off the pulleys.
 Insert a long flat blade screwdriver as shown.
 Holding the screwdriver in place, pull the new belt over
both pulleys, making sure it is properly placed.
 Remove the screwdriver.
 Tighten the bolt.

ACCESSORIES

Look for these accessories where you purchased this product or call 1-866-539-1710:
 Dado Throat Plate ........................................................................................................................................080035003093
WARNING:
Current attachments and accessories available for use with this tool are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
51 - English
BOLT
HEX
KEY
SCREWDRIVER
Fig. 80