Symbols On The Machine; For Safe Operation - IKRA PCS 5046 Instrucciones De Servicio

3. Symbols on the machine

Read operator's instruction book be-
fore operating this machine.
Wear head, eye and ear protection.
Always wear safety and slip-resist-
ant boots when operating the device.
Always wear safety and anti-vibration
(AV) gloves when operating the device.
Use the chain saw with two hands.
Warning! Danger of kickback.
Read, understand and follow all warn-
ings.
For safe operation and maintenance, symbols are carved
in relief on the machine. According to these indications,
please be careful not to make any mistake.
a) The port to refuel the „MIX GASOLINE"
Position: near the fuel cap
b) The port to refuel the chain oil
Position: near the oil cap
c) Setting the switch to the "O" position,
the engine stops immediately.
Position: rear at the left side of the
rear handl
d) Operate the choke knob.
Pull out the choke knob, close the choke;
push in the choke knob, open the choke.
Position: rear at the right side of the
rear handle.
Position: Bottom of the power unit
f) The screw under the „H" stamp is the
High-speed adjustment screw. The screw
under the „L" stamp is the Slow-speed
adjustment screw. The screw up the „T"
stamp is the Idle adjustment screw.
Position: upper-left of the rear handle
GB | Operating Instructions
e) Adjust the oil pump.
If you turn the rod by
screwdriver follow the
arrow to the „MAX" po-
sition, the chain oil flow
more, and if you turn to
the „MIN" position, less.
g) Shows the directions that the chain
brake is released (white arrow) and
activated (black arrow).
Position: Front of the chain cover
Guaranteed sound power level for this equip-
ment. L
WA
Engine manual start.
Decompression valve (if applicable)
Push in the decompression valve button to
open the valve

4. For safe operation

Before operate the product
1. Before using our products, please read this manual
carefully to understand the proper use of your unit.
2. Never operate a chain saw when you are fatigued,
ill, or upset, or under the influence of medication that
may make you drowsy, or if you are under the influ-
ence of alcohol or drugs.
3. Operate the chain saw only in well ventilated areas.
Never start or run the engine inside a closed room or
building. Exhaust fumes contain dangerous carbon
monoxide.
4. Never cut in high wind, bad weather, when visibility
is poor or in very high or low temperatures. Always
check the tree for dead branches which could fall
during the felling operation.
5. Use safety slip-resistant footwear, snug fitting cloth-
ing and eye, hearing and head protection devices.
6. Always use caution when handling
fuel. Wipe up all spills and then move
the chain saw at least ten (10) feet
(three (3) m) from the fueling point
before starting the engine.
7. Eliminate all sources of sparks or
flame (ie. smoking, open flames, or
work that can cause sparks) in the
areas where fuel is mixed, poured, or
stored. Do not smoke while handling
fuel or while operating the chain saw.
8. Do not allow other persons to be
near the chain saw when starting the
engine or cutting a wood. Keep by-
standers and animals out of the work
area. Children, pets, and bystanders
should be a minimum of 30 feet (10m)
away when you start or operate the
chain saw.
9. Never start cutting until you have a
clear work area, secure footing, and
planned retreat path from the falling
tree.
5
h) Shows the direction of the saw
chain installation.
Position: Front of the chain cover