Led Shadowlight - skilsaw SPT88 Instrucciones De Funcionamiento

WARNING
certain cutting conditions. If this occurs:
Typically, this may occur when trying to
cut workpieces that are near the maximum
c u t t i n g h e i g h t c a p a c i t y . U n d e r t h e s e
conditions, the workpiece can stop the lower
guard movement before the downward
motion of the arm can preopen the lower
guard. If this occurs:
The workpiece must be securely clamped.
•
This frees your left hand to raise the guard
1 by the lip 2 just enough to clear the
workpiece (Fig. 20b).
FIG. 20b

LED ShadowLight

NOTICE: The miter saw must be connected
to a power source for the Shadowlight
System to function.
The LED Shadowlight System is equipped
with an ON/OFF switch 1 (Fig. 21). The
Shadowlight System is independent of the
miter saw trigger switch. The Shadowlight
does not need to be on to operate the saw.
To cut through an existing pencil line on a piece
of wood, turn on the Shadowlight system, then
pull down on the operating handle to bring the
saw blade close to the wood. The shadow of
the blade will appear on the wood. This shadow
line represents the material that the blade will
remove when performing a cut. To correctly
locate your cut to the pencil line, align the pencil
line with the edge of the blade's shadow. Keep
in mind that you may have to adjust the miter or
bevel angles to match the pencil line exactly.
26
SAW OPERATIONS
The lower guard may not
automatically open under
2
1
Start the saw and begin your cut.
•
Once you have cleared the position where
•
the lower guard may bind, release the guard
and it will continue to rise automatically as
you cut.
DRY RUN—It is important to know where the
blade will intersect the workpiece during cutting
operations. Always perform the simulated cutting
sequence with the power tool switched OFF to
gain an understanding of the projected path of
the saw blade. Mentally note where the path
of saw blade will fall and set up your work to
keep your hands and arms out of the path of the
spinning blade. Adjust the clamps and fences so
that the smooth operation of the lower guard and
cutting action is not interfered with during the
cutting operation.
Always check to make sure the lower guard
is completelty functional. With the tool
disconnected from the power source, lift the
lower guard all way up and release. Lower
guard should immediately fully close. If guard
does not close all way or hesitates, stop using
tool and have tool serviced.
FIG. 21
1