Troubleshooting - skilsaw SPT88 Instrucciones De Funcionamiento

Turn the switch OFF and always remove the plug from the power source before

troubleshooting.

TROUBLE: SAW WILL NOT START
PROBLEM
1. Power cord is not plugged in.
2. Fuse or circuit breaker is tripped.
3. Cord is damaged.
4. Burned out switch.
REMEDY 1. Plug power cord into a functioning power outlet.
2. Replace fuse or reset a tripped circuit breaker.
3. Have cord replaced by an Authorized SKILSAW Service Center or Service Station.
4. Have switch replaced by an Authorized SKILSAW Service Center or Service
Station.
TROUBLE: BLADE DOES NOT COME UP TO SPEED
PROBLEM
1. Extension cord is too light or too long.
2. Low house voltage.
REMEDY
1. Replace with an adequate cord.
2. Contact your electric company.
TROUBLE: EXCESSIVE VIBRATION
PROBLEM 1. Blade is out of balance.
2. Saw is not mounted securely to the stand or workbench.
3. Arbor nut is not tight.
REMEDY 1. Discard blade and use different blade.
2. Tighten all mounting hardware.
3. See "Assembly" section, "Removing and Installing the Blade".
TROUBLE: SHADOWLIGHT IS NOT WORKING OR DIM
PROBLEM
1. Shadowlight cover is covered in sawdust or wood pitch.
2. Shadowlight on/off switch is not activated.
3. Shadowlight on/off switch is not functioning.
REMEDY
1. Clean the Shadowlight cover with compressed dry air and/or wipe with a
damp cloth.
2. Turn on the Shadowlight on/off switch.
3. Have the switch replaced by an authorized SKILSAW Service Center or
Service Station.
RECOMMENDED ACCESSORIES
Skilsaw Lubricant 80111
Skilsaw 60 tooth Carbide Blade SPT1010
Folding Miter Saw Stand SPT5002-FS
Rolling Miter Saw Stand SPT5001-RS
TROUBLESHOOTING
37