Mattel Jurassic World ALPHA TRAINING BLUE Manual De Uso página 5

GETTING STARTED
CHARGING
CONTROLLER
a
The controller is powered by a permanently installed LiPo battery, and it must be fully
charged before first use.
1. Switch off the controller before charging.
2. Plug the supplied USB cable into a powered USB port.
3. Begin charging by uncovering the USB port and plugging the charging cable firmly into the
USB port on the side of the controller.
4. The red LED will change to green when charging is complete.
5. Hold the charging plug and gently pull it out of the port when the charge is complete. NEVER
pull on the cable, as this may cause the cable to break.
6. Disconnect the USB cable from the controller before play.
7
c
b
PAIRING
a
1. Turn on Blue using the power switch.
2. Turn on the controller .
b
3. The LED indicator on the controller c
the flashing stops and LEDs display default Mood and Mode (blue and purple LEDs). If
the LED indicator does not stop flashing after around 10 seconds, switch off the controller
and Blue, then try again.
NOTE: If the controller battery charge is low, it will slowly pulse the LEDs red twice and then
go to sleep.
a
GETTING STARTED
will begin flashing white. Pairing is complete when
b
c
8