Before Putting The Equipment Into Operation - Dexter 900BS2.5 Manual De Instrucciones

4. TECHNICAL DATA
NOTE:
- the declared vibration total value has been measured in accordance with a standard
test method and may be used for comparing one tool with another;
-
the declared vibration total value may also be used in a preliminary assessment of
exposure.
WARNING:
- the vibration emission during actual use of the power tool can di er from the
declared total value depending on the ways in which the tool is used;
- avoid vibration risk such as: maintain the tool and the accessories, wear gloves
during operation, limit operating time and shorten trigger time.
- of the need to identify safety measures to protect the operator that are based on an
estimation of exposure in the actual conditions of use (taking account of all parts of
the operating cycle such as the times when the tool is switched o and when it is
running idle in addition to the trigger time).
Contents of packing
1 Belt sander with sanding belt (80 Grain)
1 Dust vacuum adaptor
1 Instruction manual (with 1 safety instructions and 1 guarantee card)
After unpacking, check the tool and accessories for damages and do not use the tool in case
something is defective.

5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION

Selecting the right grade of sanding belt
Di erent grades of sanding belt can be purchased from the store where you purchased the
tool. Available grades are: Coarse, Medium and Fine. Use a coarse grit to sand down rough
nishes, medium grit to smooth the work and ne grit to nish o . It is best to make a trial
run on a scrap piece of material to determine the optimum grades of sanding belt for a
particular job.
FR
ES
PT
IT
EL
PL
UA
RO
EN
147