Dust Extraction; Operation - Dexter 900BS2.5 Manual De Instrucciones

5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION
1. Plug the sander into a power point and with the sander belt tight, press the trigger
switch and then release it. The belt rotates for a short period.
2. Whilst the belt is running, adjust the tracking adjustment knob to align the belt to the
centre of the roller.
3. Repeat the trigger action and tracking adjustment until the belt is correctly aligned.
4.
Run the sander for a minute or so to ensure correct alignment before using the sander on
a workpiece.

Dust extraction

We recommend the use of the dust extraction facility at all times. Simply slide the dust bag
onto the dust extraction port. For longer periods of use or on large pieces of work, it is
advisable to use a suitable vacuum cleaner.

6. OPERATION

Switch on and o
WARNING: Always check that the power supply is the same as that
indicated on the nameplate of the tool.
1. To start the sander, press the trigger switch.
2.
To stop the sander, release the trigger switch.
3. If you press the lock on button while the trigger switch is depressed, the switch is kept in
the operating position. This is convenient when continuous operating for extended
periods of time is required.
4.
To release the lock on button, press and release the trigger switch.
NOTE: Always lift the sander from the work before switching on or switch o .
FR
ES
PT
IT
EL
PL
UA
RO
EN
149