Operation - Cameo SCUBA Manual De Usuario

9
LC DISPLAY
The backlit LC display shows the operating mode and additional system information.
10 CONTROL BUTTONS
MODE: Press MODE to access the selection menu as well as to go one level higher in the menu structure to the main display.
ENTER: Go one level lower in the menu structure. Confirm operating mode selection, status, and value changes, etc.
UP and DOWN: select menu options. Apply value changes, e.g. DMX address.
NOTE: Ventilation slits are located on the bottom and top side of the device. Ensure that the ventilation slits are not covered and that air can
circulate freely.

OPERATION

NOTES
As soon as the spotlight is correctly connected to the power, various pieces of information will appear on the display during startup: "Update
Wait..." (only for servicing purposes), "Motor Reset", "WELCOME TO Cameo", and the software version. The spotlight is ready after this process,
and the operating mode that was selected will activate.
MAIN DISPLAY DMX MODE
The upper line of the display shows "DMX Addr" and the lower line shows the currently set DMX start address. If there is no control signal to
the DMX input, the display will begin to flash. This flashing will stop as soon as a control signal is received.
DMX Addr
001
MAIN DISPLAY STANDALONE MODE
The lower line of the display shows the currently active standalone mode (Slave, Static). If there is no control signal to the DMX input in
Slave mode, the display will begin to flash. This flashing will stop as soon as a control signal is received.
Slave Static
CONFIGURING DMX MODE
Access the selection menu by pressing MODE. Using the UP and DOWN buttons, now select the "Mode" menu option (bottom row) and
confirm via ENTER. Using the UP and DOWN buttons again, select the "DMX" menu option and confirm via ENTER. The display will now show
"DMX Mode 05CH", confirm via ENTER. Press MODE 2x to return to the main screen. You can find tables on channel assignment in DMX
mode in these instructions under DMX CONTROL.
Menu Mode
ENTER
Mode UP/DOWN DMX
CONFIGURING DMX MODE
Access the selection menu by pressing MODE. Using the UP and DOWN buttons, now select the "DMX Addr" menu option and confirm via
ENTER. You can now set the DMX start address as desired using UP and DOWN. Confirm your input via ENTER and press MODE 1x to return to
the main screen.
Menu DMX Addr
ENTER
DMX Addr UP/DOWN 001 - 508
6
DMX mode
ENTER ENTER
05CH
ENTER