Moving The Saw; Cleaning The Saw; Water Pump Maintenance - Brutus 61024BR Instrucciones De Funcionamiento

STEP 4: Tighten the bevel adjustable knob when the
cutting head is positioned on the desired angle.
STEP 5: Turn on the power and make bevel cuts by
pushing the cutting table toward the cutting head.
45°–90°
FIGURE 21
FIGURE 22
MAINTENANCE
MAINTAIN THE SAW WITHOUT FIRST TURNING OFF
THE MOTOR AND UNPLUGGING THE SAW FROM ITS
POWER SOURCE. FAILURE TO DO SO MAY RESULT IN
SERIOUS INJURY TO THE OPERATOR.

MOvING ThE SAW

Before moving the saw, be sure to tighten the
slide tube locking knob (FIGURE 17), to prevent main
working table from sliding randomly during transport.
• When moving the saw short distances around the job
site, unlock the wheels on the bottom of the stand and
move the saw with the stand attached.
• When moving the saw longer distances, detaching the
saw from the stand and use the wheels on the saw
Bevel
adjustable
knob
DO NOT SERVICE, CLEAN, OR
frame (FIGURE 23). The stand folds up separately for
easy transport (FIGURE 24).
FIGURE 23
FIGURE 24

CLEANING ThE SAW

For the long life and best performance of saw:
• Always clean the saw after each use.
• Wipe off all exterior surfaces and keep the cutting table
clean and free of debris.
• Wipe off the cutting table guide bars and rollers.
• Keep ventilation slots of the motor clean to prevent
overheating.
• Always check the blade for cracks or signs of damage.
• Clean the side extension table tubes after each use.
NOTE: NEVER attempt to service the internal parts of
the motor. Contact our company's Customer Service
Department for any motor function problems or failures.

WATER PUMP MAINTENANCE

BEFORE MAINTENANCE OF THE PUMP.
1. Disassemble the water pump to see if any cracks or
dirt are inside (FIGURE 25).
2. Check if the water tubing is clogged where the water
cannot flow. Clear the tubing with warm water.
3. Make sure pump is plugged in during use.
– 10 –
DISCONNECT THE POWER