Before Operation; Control Elements - TECshow LINK USB 2.0 Manual De Usuario

3. FEATURES
• 2 analog signal input and output
• 1 S/PDIF digital signal coaxial output
• Switch-able Phono/LINE input mode
• LED power status indicator
• USB bus-powered

4. BEFORE OPERATION

Please read this manual carefully to take full advan-
tages of Link USB 2.0. Make sure that Link USB 2.0
works at a place with good ventilation. Do not put
it on a heavy heater source (as amplifier, electric
oven). Link USB 2.0 is directly powered by USB
power supply. Therefore, please comply with the
relative safety regulations during operation.

5. CONTROL ELEMENTS

2
1
3 4
1. USB poert: A type B USB port, connect to PC
with the B inverting A type connector USB
cable;
2. Power Indicator: Connect to PC with the Bin-
verting Atype connector USB cable, the LED will
light on;
P. 4
Tecshow USB 2.0 | English version
7
6
6
4 5
3. Grounding pillar: Generally, when the phono
input source is selected, grounding pillar is con-
nected to the phono signal ground, which can
reduce input noise;
4. Left/right inputs: Receive the output signal from
the audio source like tape recorder and /or
phono etc.
5. Phono/ line mode switch: When input high
level audio source(like tape) is selected, turn
this switch to "LINE"; while input phono audio
source is selected, turn it to "PHONO";
6. Left/right outputs: Used to connect active
speakers;
7. S/PDIF digital signal outputs: Used to con-
nect audio amplifier with S/PDIF digital input
through coaxial RCA cable.