Operation; Bead Breaking - Nussbaum TC 310 Manual De Instrucciones

3) Depress the pedal all the way down (5, Fig. L): the four clamps (6, Fig. L) on the table top will
open. When the pedal is depressed again, the clamps should close.
4) Depress the pedal (7, Fig. L) to tilt the post (8, Fig. L) back to non-working position.
Depress the pedal again, the post will recouple in its working position.
5) Press the yellow pushbutton (1, Fig. M2): the vertical slide (10, Fig. L) descends, facilitating
the positioning of the toolhead against the rim flange.
Press the red pushbutton (2, Fig. M2); the operating arms are locked simultaneously, and the tool-
head automatically moves away 2 mm from the rim flange (see chapter on demounting).
Press the toggle switch (3, Fig. M2); all the operating arms are unlocked simultaneously and the
vertical slide is raised (10, Fig. L).
6) Check that a drop of oil drops into the lubricator glass cup (12, Fig. L) after every two or three
movements of the footpedals (3 or 5, Fig. L).
Oil feed may be regulated by means of the Lubricator adjusting screw (see Fig. M3).
WARNING!
During all operations, keep hands and other parts of the body as far as possible from moving parts of the machine.
Necklaces, bracelets and too large clothes, can be dangerous for the operator.
WARNING!
The optional PT accessory and/or other specific accessories are required to work on RUN FLAT, LOW PROFILE
or UHP wheels. For use of the accessories and the correct operating procedure, refer to the manuals supplied
with the accessories themselves, approved by WDK.
WARNING!
Bead breaking must be done with the utmost care and attention.
When the bead breaker pedal is operated the bead breaker arm moves quickly and powerfully.
Anything within its range of action can be in danger of being crushed.
WARNING!
Remember to remove all weights from both sides of the rim before operating the machine.
1) Deflate the tyre completely and remove the valve core.
2) Close the table top gripper slides completely.
WARNING!
Bead breaking with the table top slide grippers open can crush the operator's hands.
During bead breaking NEVER touch the walls of the tyre with your hands.
TC 310 - Liga C 250

10. OPERATION

10.1 BEAD BREAKING

32
ENGLISH • Instructions manual
1
2
3
M2
M3