Positioning The Riving Knife; Attaching The Guard Assembly; Attaching Smart Guard System Components - skilsaw SPT70WT Instrucciones De Funcionamiento Y Seguridad

2610039875 12-15 E_SPT70WT 12/23/15 10:54 PM Page 13
ATTACHING THE SMART GUARD SYSTEM
To prevent personal injury, al-
ways dis con nect plug from
WARNING
power source before attaching or removing
the Smart Guard System.

POSITIONING THE RIVING KNIFE

1. Remove table insert using finger hole.
2. Raise the blade as high as it will go and set it
perpendicular to table (0° on bevel scale)
(Fig. 5).
3. Rotate the riving knife release lever clockwise,
so that it points upward (Fig. 5).
4. Pull riving knife towards release lever to disen-
gage it from the pins.
5. Slide the riving knife up to its highest position,
so that it is directly over the center of the blade
(Fig. 6).
6. Align holes in riving knife with pins and lock the
release lever by rotating it counterclockwise.
Push/pull riving knife to verify that it is locked in
place (Fig. 6).
7. Replace table insert (Fig. 7).

ATTACHING THE GUARD ASSEMBLY

8. With one hand, hold the front of the barrier
guard assembly by the metal "fork". With the
other hand, hold the guard release lever up
(Fig. 7).
9. Lower the rear of guard assembly and slip the
cross bar into the rear notch on top of the riv-
ing knife (Fig. 7).
Assembly
Guard Release
Lever
Riving Knife
-13-
FIG. 5
Riving Knife
Release Lever
FIG. 6
Pins
FIG. 7
Rear Notch
Cross Bar