Olympus PT-E05 Manual De Instrucciones página 62

Insert the digital camera in the Case
Load the digital camera in the Case after checking the following:
• Is the digital camera turned OFF?
• Is camera media (either xD-Picture Card or CompactFlash) loaded into the camera?
• Is the battery fully charged?
• The strap, lens cap and filter are removed from the digital camera.
• The camera table provided with the Case is attached to the tripod screw hole at the bottom of the digital
camera.
• The camera's eyecup is removed from the camera's viewfinder.
• The zoom gear and focus gear are attached to the camera's lens.
1 Pull out the zoom dial and mode dial on the Case (pulling out the mode dial also pulls up the power
switch lever) so that they do not get in the way while loading the digital camera.
At this time, set the orientation of the power switch lever as shown below.
2 When using an electronic flash with a TTL cable, remove the TTL cable connector cap on the hot
En
shoe connector, which is located in the top left corner of the inner side of the front lid. and connect
the TTL cable to the connector.
CAUTION:
When screwing in the hot shoe connector clamping screw, place the Case upside down. Be careful not to
drop the Case.
EN 21
Remove the cap by turning it
counterclockwise.