Bresser TemeoTrend SW Manual De Uso página 37

• Ideally, place the remote sensor over soil, rather than asphalt
which may affect the correct measurement.
• Avoid placing the remote sensor near sources of heat, such as
chimneys and heating elements
• Avoid areas that collect heat from the sun and radiate heat,
such as metal, brick or concrete structures, paving, and patios
• The international standard for the valid air temperature measure-
ments is 1.25meters (4 feet) above the ground
• Make sure that the main unit is locating within the operating
range of all remote sensors.
• Ideally the main unit should be placed within line of sight of
remote sensors. Avoid placing the main unit where surfaces
emitting and radiating heat (e.g. heating ducts or air conditio-
ners) and areas with interference from wireless devices (e.g.
cordless phones, radio headsets, baby monitoring devices and
other electronics).
Important notice about batteries
• The TemeoTrend is delivered with batteries to make the start-
up easy for you. These batteries may not last as long as fully
new batteries may. Once you have to replace the batteries on
the outside sensor, we recommend to use alkaline batteries.
Advantage of this is a better performance in case the outside
temperature falls below 0° (32°F). For optimum performance,
we recommend even lithium batteries.
• Avoid using rechargeable batteries. (Rechargeable batteries
cannot maintain correct power requirements.)
• ALWAYS install batteries in the remote sensor before the main
unit.
• Insert batteries before fi rst use, matching the polarity in the
battery compartment.
37
GB/IE