Heating; Preparing Coffee; Steam Distribution; Drawing Hot Water - Bezzera BZ07 DE Manual De Instrucciones

The machine will signal this alarm by turning
off the yellow light and turning on the keypad
LEDs.
To restore working mode, turn off and turn on
the machine again.

5.2 Heating

In order for the machine to reach the right
temperature, with the pressure indicated on the
boiler gauge (Fig. 01; pos. 11) between 1 and 1.2
bar (0.1 - 0.12 MPa), open the steam tap (Fig. 01;
pos. 9) and discharge the steam 2 or 3 times into
the discharge basin.
The yellow light (Fig. 01; pos. 3), if turned on
indicates that the machine is working correctly, if
turned off means insufficient water in the tank (S
version), in the boiler (R version).

5.3 Preparing coffee

1) Remove the filter holder (Fig. 01; pos. 6) from
the distribution unit (Fig. 01; pos. 5).
2) Load the filter holder with ground coffee, press
the coffee down taking care to not dirty the
edge of the filter holder.
3) Reattach the filter holder in its housing.
PM VERSION
4) Start up coffee distribution by pressing the
distribution button (Fig. 04; pos. a).
5) Stop distribution when the desired quantity is
reached, by pressing the distribution button
again.
DE VERSION
4) Use the coffee distribution keypad (Fig. 05),
by pressing one of the keys, depending on the
desired dose.
To change dose programming, follow the
instructions in paragraph 5.7 of this booklet.
The machine is set for continuous distribution:
press the key " " (Fig. 05; pos. c) to start up
distribution, press again to stop..
Warnings:
- Do not remove the filter holder full of coffee when
the machine is working, as it is pressurised.
- Do not touch the metal part of the filter holder
directly as it is hot.

5.4 Steam distribution

1) To avoid liquids being sucked into the boiler,
discharge the steam by turning the tap knob
(Fig. 01; pos. 9).
2) Insert the steam nozzle (Fig. 01; pos. 10) in the
container of the liquid to be heated.
3) Press down and hold the steam tap knob (Fig.
01; pos. 9), lifting the lever the tap will remain
in open position (Fig. 06). The amount of steam
distributed is proportional to the opening of
the tap; the more the tap is opened, the more
steam will be distributed.
4) Once steam has been distributed, release
knob, remove liquid container and clean the
steam nozzle immediately with a damp cloth to
remove heated liquid residues.
Warning: Do not touch the steam nozzle directly
as it is hot.

5.5 Drawing hot water

1) Place the water container under the nozzle (Fig.
01; pos. 8).
2) Press down and hold the water tap knob (Fig.
01; pos. 7) to draw the amount of water
required.
3) Once water has been distributed, release the
knob.
Warning: Do not touch the water distributor tap
directly as it is hot.

5.6 Turning off the machine

1) Turn the main switch (Fig. 01; pos. 1) to position
"0" and check that the green light has turned
off. (Fig. 01; pos. 2)
27
MOD. BEZZERA BZ07
(Fig. 06)