Maintenance - Urrea AS810 Manual De Usuario

Deluxe
• Insert snap-in and out.
Elbow swivels
Carpet tool insert
Squeege insert
All friction fit accessory
• Insert wand and or
hose into accessory and
twist to form a tight fit.
HOSES
All friction fit hoses
• Insert machine hose
end into tank and twist
to form a tight fit.
Posi-lock hoses
• Insert hose collar onto
thread tank inlet and
tighten.
WANDS
All friction fit wands
• Insert wand ends to-
gether and twist to form
a tight fit.
Positive locking wands
• Insert wand ends to-
gether until metal push
button locks.
AUTOMATIC SHUTOFF
The vacuum cleaner is equipped with an auto-
matic shutoff that operates when picking up
liquids. When the liquid in the tank reaches a
certain level, an internal float will seat itself
against a seal at the intake of the motor, shut-
ting off suction. When this happens, the motor
will develop a higher than normal pitch noise
E N G L I S H •
indicating that you need to switch off the vac
and empty the liquid.
NOTE: If accidently tipped over, the float shut-
off device could seat against the seal and shut
off suction. If this happens, simply place the
vacuum cleaner in upright position and turn
off the switch until the float returns to its nor-
mal position.
CAUTION, EMPTYING TANK:
Use special care when emptying heavily loaded
tanks. Your Wet/Dry Vacuum may be emptied
of liquid waste by removing the tank cover. To
empty, switch off the vac and remove the plug
from the wall receptacle. Remove the tank
cover and empty the tank.
NOTE: For those models with a drain plug, tank
can be emptied by removing drain cap and
draining liquid waste into a suitable drain.

MAINTENANCE

WARNING: Be sure to disconnect power
supply before attempting to service or remove
any components.
STORAGE
Before storing the vacuum cleaner, always
empty and clean the tank. Never allow liquids
to sit in the tank for any extended period of
time. Always store the vacuum cleaner in-
doors.
LUBRICATION
No lubrication is necessary as the motor is
equipped with lifetime lubricated bearings.
SERVICE
Do not attempt to service your wet/dry vacuum
cleaner beyond that described in this manual.
Refer all other servicing to a qualified service
center.
WARNING: If any of the motor housing
parts should become detached or broken, ex-
posing the motor or any other electrical com-
ponents, operation should be discontinued im-
mediately to avoid personal injury or further
damage to the vacuum. Repairs should be
made before reusing the vacuum.
U se r's m a nua l
17