Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SEAR STATION'" BURNER LIGHTING
Summary
lighting instructions
are inside the left hand cabinet door.
DANGER
Failure to open the lid while igniting the barbecue's
burners,
or not waiting 5 minutes to allow the gas to clear if the
barbecue
does not light, may result in an explosive flame=up
which can cause serious
bodily injury or death.
The Sear Station"
burner has an on or off control setting.To
ignite the Sear Station
TM
burner you must first ignite the two adjacent
main burners.
ADJACENT
MAiN BURNER SNAP IGNITION
Note: Each main burner control knob snap igniter creates a spark from the igniter
electrode
to the burner lighting tube. You generate the energy for the spark by pushing
in the control knob and turning to"START/HI"This
will ignite each individual bume_
WARNING: Check hose before each use of barbecue
for
nicks, cracking, abrasions
or cuts. If the hose is found to
be damaged in any way, do not use the barbecue.
Replace
using only WebeP authorized
replacement
hose. Contact
the Customer Service Representative
in your area using the
contact information on our web site. Log onto www.weber.
coin ®.
1)
Open the lid.
2)
Make sure all burner control knobs are turned off. (Push control knob in and turn
clockwise
to ensure that it is in the "OFF" position.)
3)
Turn the cylinder on by turning the cylinder valve counterclockwise.
z_ WARNING: Do not lean over the open barbecue.
4)
Ignite each adjacent
Sear Station" main burner. Push the control knob in and turn
to "START/HI" until you hear the igniter snap - continue
to hold control knob in for
two seconds. This action will spark the igniter, the burner lighting tube and then
main burner.
5)
Check that the burner is lit by looking through the cooking grates. You should see
a flame. If burner does not light on first try, push control knob in and turn to OFR
Repeat lighting procedure a second time.
To ignite the Sear Station'" burner continue
with Step 6.
Sear Burner Lighting:
Ignition by an adjacent
ignited
Main BumeK
6)
Turn -Sear Station"
burner control knob to the ON position.
7)
Verify burner ignition by visual inspection
of a flame.
Z_ WARNING: If ignition does not occur in 5 seconds,
turn
burner control OFF, wait 5 minutes,
and repeat steps 6 & 7, or
see Match Lighting
instructions.
WARNING: If the burner still does not light, turn the burner
control
knob to "OFF" and wait 5 minutes to let the gas clear
before you try again or try to light with a match.
Note: See Maintenance
for burner removal and cleaning
procedure.
ARR_:TE
EN MARCHE
OFF O
O ON
APAGADO
ENCENDIDO
SEAR STATION
TM
BURNER LIGHTING
*The grill illustrated
may have slight'__
I
_
1
differences
than the model purchased.
-'_-_
@
TO EXTINGUISH
Push in and turn each burner control knob clockwise
to "OFF" position.Turn
gas supply
off at the source.
Publicidad
Tabla de contenido
