Contact Information On Our Web Site; Log Onto Www.wEber.cOm; Danger; Bodily Injury Or Death - Weber Summit E/S-470 Guia Del Propietario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LIGHTING THE ROTISSERIE
BURNER
ROTISSERIE BURNER SNAP IGNITION
Note: Each centre/knob
snap igniter creates
a spark from the igniter electrode
to the
burner fighting tube. You generate
the energy for the spark by pushing in the centre/
knob and turning to "START/HI".
This wi// ignite each individual
burner.
ATTENTION:
READ BEFORE
LIGHTING ROTISSERIE
BURNER
After a period of non-use, before lighting the Rotisserie
Burner, a few seconds
must pass for the gas supply
line to
fiH.
When using the snap igniter you wiil see a flash of flames
moving from left to right across the Rotisserie
Burner
surface,
the Rotisserie Burner is not lit until the entire
ceramic
surface
is aflame.
At this point, start a count of 20 seconds
before releasing
the
Rotisserie
Burner control
knob.
The Rotisserie
Burner surface will glow red once the burner
is fully ignited.
*The grill illustrated
may have slight
differences than the model
purchased.
DANGER
Failure to open the lid while igniting the grill, or not waiting
5 minutes to allow the gas to clear if the grill does not light,
may result in an explosive flare=up which can cause serious
bodily injury or death.
z_ CAUTION: The Rotisserie Burner flame may be difficult to
see on a bright sunny day.
z_ WARNING: Check hose before each use of griJJ for nicks,
cracking,
abrasions
or cuts. If the hose is found to be
damaged in any way, do not use the grill Replace using
only a Weber _ authorized
replacement
hose. Contact
the
Customer
Service Representative
in your area using the
contact
information on our web site.
Log onto www.weber.com
®.
1)
Open the lid.
2)
Remove the warming
rack and the cooking grates from the cookbox.
3)
Make sure all burner control knobs are turned to "OFF". (Push control knob in and
turn clockwise
to ensure that it is in the "OFF" position.)
4)
Turn on the gas at source.
Z_ WARNING:
Do not lean over the open grill.
5)
Push the control knob in and turn to "START/HI".
This action will spark the igniter
and light the Rotisserie
Burner. Continue to use the snap igniter until the Rotisserie
Burner has ignited. Release the control knob.
6)
Check that the burner is lit by looking for the rotisserie burner to glow red.
Z_ WARNING: If the rotisserie burner does not light, turn the
burner control knob to "OFF" and wait 5 minutes to let the
gas clear before you try again or try to light with a match.
Note: When using the rotisserie with the lid closed, only fight two of the main burners
on each side of the food (See Gd//ing Methods-Indirect
Cooking).
Check your food
periodicafly
to prevent over cooking
on the outside. Turn off the rotisserie
burner once
the food has browned
to the desired
co/or. Finish cooking
on Indirect
heat.
TO EXTINGUISH
Push in and turn each burner control knob clockwise
to "OFF" position. Turn gas supply
off at the source.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Summit 89372

Tabla de contenido