PROBLEH
CHECK
CURE
Burners
burn with a yellow
or orange
Inspect Spider/Insect
Screens for possible
Clean Spider/Insect
Screens. (See Section 'Annual Maintenance")
flame, in conjunction
with the smell
obstructions.
(Blockage
of holes.)
of gas (This is normal
for the burner
lighting tube).
Sear Station
burner
does not light.
Did you ignite the two adjacent
main burners
Verify adjacent main burner ignition by visual inspection
of a flame.
(See Sear Station burner lighting instructions
for safe lighting procedure)
z_ WARNING:
if ignition does not occur
in 5 seconds,
turn burner
control
OFF, wait 5 minutes
to let the gas c/ear before you try again
Does Burner light with a match?
If you can light Burner with a match, then check the Crossover ¢ Channel on the sear
burner. (See Maintenance
for burner removal and cleaning
procedure.)
Does the igniter work (Do you see a spark
Try manually lighting the burner (refer to "Lighting the Rotisserie
Burner"). Call
when you repeatedly use the snap igniter?
customer
service.
if problems
cannot
be corrected
by using these methods,
please contact
the Customer
Service
Representative
in your area using the contact
information
on our
web site. Log onto www.weber.com
'_.
OPERATING
THE HANDLE LIGHT
The Weber Grill Out
TM
Handle Light has a built-in "Tilt Sensor." With the power button (a)
activated,
the light will come on when the grill lid is open. The light will turn off when the lid
is closed. For daytime use, deactivate
the sensor by pressing power button (a).
PROBLEM
CHECK
Weber Grill Out
TM
Handle
Are the batteries old?
Light does not light.
Are the batteries installed correctly?
Is the lid in the up position with the power button ON?
Is the Weber Grill Out
TM
Handle Light activated?
Is the Weber Grill Out
TM
Handle Light positioned
correctly on the handle?
if problems
cannot
be corrected
by using these methods,
please contact
the Customer
Service Representative
in your area using the contact
information
on our web
site. Log onto www.weber.com
®.
CURE
Replace batteries.
See assembly
illustration.
Light will activate when lid is open.
Press the power button.
Adjust position (See assembly
illustration).