Electrical Connection - Twinstar Home 73696/18SM9977-PC76 Manual De Instrucciones

7. Remove the two mounting brackets attached to the
back of the Left and Right Front panels.
Set aside with the wood screws.
PLEASE READ ALL "ELECTRIC FIREPLACE
INSERT" INSTRUCTIONS PRIOR TO INSTALLING
ELECTRIC INSERT IN YOUR COMPLETED
FIREPLACE MANTEL. INSTALL THE INSERT IN
YOUR FIREPLACE
Lift insert carefully into the back of the unit and
center in the insert opening. Do not drag insert
across Hearth/Base (A) as it may scratch your unit.
Install the mounting brackets to hold insert fl ush
against the inside of the mantel front panel.
MOVE YOUR COMPLETED UNIT ONLY SHORT
DISTANCES. MOVE COMPLETED UNIT WITH
GREAT CARE. IT TAKES TWO PEOPLE TO
MOVE COMPLETED UNIT INTO ITS FINAL
POSITION.
Cold climate installation recommendation: When installing this unit against a non-insulated
exterior wall or chase, the outer walls must be insulated to conform to applicable insulation
codes.

ELECTRICAL CONNECTION

A 15 AMP, 120 V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the fi replace will
be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or
the fuse to blow when the heater is in operation. The unit comes standard with 6 ft. (1828 mm) three
prong cord, exiting from the rear of the fi replace. Plan the installation to avoid the use of an extension
cord. If an extension cord must be used, it must be a minimum 14 AWG, three wire with grounding type
plug connector and rated not less than 1875 watts. The cord shall not be more than 20 ft. in length.
Fig. 7
Mounting
Bracket
Fireplace Insert
Completed
Unit
9
Install
Insert
From
Back
Electric