IMPORTANT INFORMATION
22. Avoid the use of an extension cord because the extension cord may overheat and cause risk of fi re.
However, if you have to use an extension cord, the cord must be No.14 AWG minimum size and rated
not less than 1875 watts. The extension cord must be a three-wire cord with grounding type plug and
cord connection. The extension cord shall not be more than 20 ft. in length.
23. See directions in Figure 1. This heater is for use on 120 volts. The cord has a plug as shown in figure
1. See Figure 1 for grounding instruction. An adapter as shown at C is available for connecting three-
blade grounding type plugs to two-slot receptacles. The green grounding plug extending from the
adapter must be connected to a permanet ground such as a properly gounnded outlet box. The
adapter should not be used if a three-slot grounded receptacle is available.
Grounding Pin
Grounding
Means
PRODUCT SPECIFICATIONS
VOLTAGE
AMPS
WATTS
Metal
Screws
B
A
C D
Fig. 1
120 VAC, 60 Hz
12.5 Amps
1500 Watts
SAVE THESE
INSTRUCTIONS
3