Craftsman 316.380700 Manual Del Operador página 6

,',SAFETY & iNTERNATiONAL SYMBOLS ,,,
This operator's manual describes safety and international symbols and pictographs that may appear on this product. Read the operator's
manual for complete safety, assembly, operating and maintenance and repair information.
SYMBOL MEANING SYMBOL MEANING
_ ',,,SAFETY ALERT SYMBOL
indicates danger, warning
I conjunct on w th other symbo s or p ctographs,
[_ o READ OPERATOR'S MANUAL
J
WARNING.
Read
the operators manua!(s)
and follow al! warnings and safety instructions. Failure
to do SOcan result in serious injury to the operator
. and/or bystanders.
_ • WEAR HEAD; EYE AND HEARING PROTECTION
i i ev e Y " j _ nd " g i :W a
eye protect!on meeting current ANSI Z87,1 standards
'and ear protecti0n when operating this unit, Wear
head protecti0n when operating this unit; falling
objects can cause severe head injury, Use a ful! face
shield when needed.
_ • UNLEADED FUEL
_÷÷H, A!WaYS Use c ean;![eSh un eade d fue!:
,,,OIL
. Refer to operator s manual for the proper type 0f 0il,
• DO NOT USE E85 FUEL IN THIS UNIT
,,,,,_,-,,,,,,,,,,,_. ,thas be00 proven that rue,
containing greater than 10% ethanol wil! likely
damage this engine and void the warranty,
I ' ON/OFF STOP CONTROL
ON / START / RUN
0
_) , PRIMER BULB
_rJ! Push pr mer bu b, fully and s owly, 10 times.
u i
.c.o c
• Pulled Out - FULL choke position
• Pushed In - RUN position
[vlin.50ft(15m) D
KEEP BYSTANDERS AWAY
_1_$ WARNING:--Keepa
bystanders especay
children and pets, at least 50 feet (15 m) from the
operating area.
' USE BOTH HANDS ,,,,
WARNING:
AIwaysusebothhandswhe
cO P: rr a ttien t gteh e nU tnit" Never use Only One hand tO
A WARNING:
Contact of the guide bar t p
' KICKBACK =
with any object should be avoided. Tip contact may
cause the guide bar to move suddenly upward and
_-'---':@ backward, which may cause serious injury.
' CHAIN OIL ADJUSTMENT INDICATOR
The chain must be continously coated with oil to
function properly. Make sure to set the oil adjustment
screw to allow a sufficient amount of oil to flow
continuously onto the chain.
"_= ,,,,,_ ' CHAIN BRAKE
cha,n ,mme, ,ato,y stops the m ov,n0 saw
chain in emergency situations. To manually engage
the chain brake, push the chain brake lever forward
completely. To disengage the chain brake, pull the
. chain brake lever back completely.
_c:_ ' CHAIN DIRECTION
Make sure the saw chain faces the direction shown
when installed on the guide bar. Refer to Installing the
. Guide Barand Saw Chain in the Maintenance section.
_ _ , CHAIN TENSIONING
Always keep the saw chain properly tensioned. Turn
the chain-tensioning screw clockwise to tighten the
saw chain. Turn the chain-tensioning screw
counterclockwise to loosen the saw chain.