Assembly Of The Appliance - Ningbo Innopower Hengda Metal Products ORIOPOWER H5202 Manual De Instrucciones

ASSEMBLY OF THE APPLIANCE

ASSEMBLY INSTRUCTIONS
Before assembly, make sure all packing and transit protection material must be removed.
After removing the heater from its packaging, check it for damage: if you are unsure, do not use
the appliance and contact qualified service personnel. The packing materials should not be left
within the reach of children because they are potentially dangerous; dispose of them in
conformity with the law.
1. Fold the base plate, on which the gas
cylinder will stand, downwards.
2. Fix base plate into rear housing through
4pcs washers and bolts.
 Small deviations may occur. This is not related to quality but subject to improvements.
The appliance must only be powered with LPG gas less than 15-kg cylinder.

 The regulator must be EN12864 approved and the hose must be EN1763-1 approved with a length
less than 50 cm.
 Connect one end of the hose to the pressure regulator and the other end of the hose to the tap.
Make sure that the connections are tight and there is no damage to any component or fitting.
 Before connecting the cylinder, make sure that its tap is closed and there are no open flames (lit
oven, etc.) in the vicinity and the gasket seal is in good condition. Then screw the pressure
regulator onto the cylinder.
 Attach the regulator to the tap, screw the nut tightly counterclockwise.
 Carefully check that there is no gas leaking from the connection using soapy water (one part
detergent and three parts water). If there is a leak, bubbles will form; tighten the connection more
or seek professionally qualified service.
 Place the cylinder in its compartment, taking care that the tube is not twisted or choked and doesn't
touch any hot parts.
STEP 1
1. Attach the tank cover to the slots in the
housing side sections.
- 16 -
GB
STEP 2