Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
C) TECHNICAL CHARACTERISTICS
1) GENERAL
- Channels
(according to the selected band) : 40 channels
- Frequency range
- Frequencies
- Operating Temperature Range
- DC input voltage
- Size
- Weight
2) RECEIVER
- Receiving system
- Intermediate Frequency
- Sensitivity
- Audio Distortion
- Image rejection
- Adjacent Channel rejection
- Signal/Noise Ratio
- Current drain at Standby
3) TRANSMITTER
- Output power
- Modulation
- Frequency response
- Output impedance
- Signal/Noise Ratio
- Current Drain
: 26.965 to 27.405 MHz
: PLL
: -10°C / +55°C
: 13.2 V DC ±15%
: 140 (L) x 180 (H) x 35 (D) mm
: 0.850 kg
: Dual Conversion Super hétérodyne
: 1° IF :10.695 MHz, 2° IF : 455 MHz
: 0.5 µV for 20 dB SINAD in FM
: less than 8% @ 1 KHz
: 65 dB
: 65 dB
: 45 dB
: 325 mA
: 4W@ 13.2 V DC
: FM : 1.8 KHz ± 0.2 KHz
: from 400 Hz to 2.5 KHz
: RF 50 Ohms
: 40 dB MIN
: 1300 mA
D) TROUBLE SHOOTING
1) YOUR CB RADIO WILL NOT TRANSMIT OR YOUR TRANSMIS-
SION IS OF POOR QUALITY
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that the microphone is properly plugged in.
2) YOUR CB RADIO WILL NOT RECEIVE OR RECEPTION IS POOR
- Check that the squelch level is properly adjusted.
- Check that the volume is set to a comfortable listening level.
- Check that the microphone is properly plugged in.
- Check that the antenna is correctly connected and that the SWR is properly
adjusted.
- Check that you are using the same modulation mode as your correspondent.
3) YOUR CB WILL NOT LIGHT UP
- Check the power supply.
- Check the connection wiring.
- Check the fuse.
E) HOW TO TRANSMIT OR RECEIVE A MESSAGE
Now that you have read the manual, make sure that your CB Radio is ready
for use (i.e. check that your antenna is connected).
Choose your channel (19, 27).
Choose your mode (AM/FM) which must be the same as that of your
correspondent.
Press the «push-to-talk» switch and announce your message «Attention
stations, transmission testing» which will allow you to check the clearness and
the power of your signal. Release the switch and wait for a reply. You should
receive a reply like, «Strong and clear».
If you use a calling channel (19, 27) and you have established communica-
tion with someone, it is common practice to choose another available
channel so as not to block the calling channel.
29
Publicidad
Tabla de contenido
