Making A Miter Cut - RIDGID R4513 Manual Del Operador

OPERATION
MAKING A RIP CUT
See Figure 50.
WARNING:
Make sure the blade guard assembly is installed
and working properly to avoid serious personal
injury.
WARNING:
Taper cuts must only be made with a special jig,
which is commercially available. Do not attempt
a free hand taper cut on this saw. Failure to
follow these instructions could result in serious
personal injury.
 Set the blade to the correct depth for the workpiece.
 Position the rip fence the desired distance from the blade
for the cut and securely lock the handle.
 When ripping a long workpiece, place a support the same
height as the table surface behind the saw for the cut
work.
 Install feather board in the appropriate position for the
cut being made.
 Make sure the wood is clear of the blade before turning
on the table saw.
 Turn the saw on.
 Position the workpiece flat on the table with the edge
flush against the rip fence. Let the blade build up to full
speed before feeding the workpiece into the blade.
 Using a push stick and/or push blocks, slowly feed the
workpiece toward the blade. Stand slightly to the side of
the wood as it contacts the blade to reduce the chance
of injury should kickback occur.
 Once the blade has made contact with the workpiece, use
the hand closest to the rip fence to guide it. Make sure
the edge of the workpiece remains in solid contact with
both the rip fence and the surface of the table. If ripping a
narrow piece, use a push stick to move the piece through
the cut and past the blade.
 When the cut is made, turn the saw off. Wait for the
blade to come to a complete stop before removing the
workpiece.

MAKING A MITER CUT

See Figure 51.
WARNING:
Make sure the blade guard assembly is installed
and working properly to avoid serious personal
injury.
BLADE
BLADE
STRAIGHT
 Set the blade to the correct depth for the workpiece.
 Remove the rip fence by lifting the locking lever.
 Set the miter gauge to desired angle and tighten the lock
knob.
 Make sure the wood is clear of the blade before turning
on the saw.
 Turn the saw on.
 Let the blade build up to full speed before moving the
workpiece into the blade.
33 − English
RIP CUT
RIP FENCE
PUSH
BLOCK
MITER CUT
MITER GAUGE
ANGLED
BEVEL
ADJUSTING
HANDWHEEL
PUSH
STICK
Fig. 50
Fig. 51