Roadstar CD-900USMP Manual De Instrucciones página 8

Under MP3 play mode, press AS/PS BUTTON (12) three times. Then the first Directory
name is shown. Rotate VOLUME UP/DOWN to navigate through the directory list, press
VOLUME/ENTER BUTTON (3) to select the desired directory. The display will show " \\ ".
To select the tracks under the selected directory, rotate VOLUME UP / DOWN then press
VOLUME/ENTER (3) to confirm when desired track is found.
Rotate the Volume knob (3) in both directions to scroll through the characters
(alphanumerical). Then press VOLUME/ENTER (10) to confirm.
ID3 Tag
Press CLK button on Remote Control repeatedly to Display ID3 TAG information.
If the MP3 file is available with ID3 TAG, pressing the CLK button repeatedly will show
information in the following sequence:
SONG TITLE > ARTIST> ALBUM TITLE > YEAR> COMMENTS
If any of the ID3-TAG information is not available, pressing the DISPLAY button re
peatedly will show information in the following sequence:
UNKNOWN SONGNAME> UNKNOWN ARTIST> NO ALBUM TITLE > UNKNOWN
YEAR > NO COMMENTS
If the MP3 file is without ID3 TAG, pressing the CLK button, "NO ID3 TAG" will be
displayed.
The file name & track number of the MP3 file will scroll repeatedly through the display
during the playing of the MP3 file.
27. TAPE EJECT KEY
In TAPE mode, push this key fully to stop tape playback and release cassette tape. The
car radio cassette player will automatically go into radio mode.
28. CASSETTE TAPE DOOR
In RADIO mode, insert a cassette into this slot, the tape playback starts automatically.
29. FAST FORWARD / REVERSE BUTTON
For fast-forward, push in the button (>>) which indicates the same direction of the lighted
tape direction indicator. For rewind, push the button (<<) with the arrow marks in the opposite
direction of that shown by the tape direction indicator. At the end or tape in either fast forward
or rewind, the unit will automatically select play mode. To release either fast forward or
rewind button from the lock position, push in the other button approximately half-way. During
tape play, pushing both fast forward and rewind buttons simultaneously will change the
direction of tape travel.
English 11 12
SPECIFICATIONS
CD / USB / SD MP3 PLAYER SECTION
Signal to Noise Ratio
Channel Separation
Frequency Response
TUNER
Sensitivity
Stereo separation
Signal to noise radio
Frequency range
Channel step
Intermediate frequency
LINE-OUT
Output
Impedance
GENERAL
Power Supply
Speaker impedance
Output power
Note: Specifications and the design are subject to possible modification without notice due
to improvement.
English
> 70dB
> 50 dB (1kHz)
20Hz - 20 kHz
2 dBμ
35 dB
55 dB
FM 87.5-108 MHz
AM 522-1620 KHz
50 kHz
10.7 MHz
350mV max.
10kOhm
13.8V DC
(10.8-15.6V allowable)
4 or 8 ohm
25W RMS x 4CH