Operation; Using Different Areas Of The Facial Brush; Operation Modes And Speed Settings; Switching On/Off And Selecting An Operation Mode - Silk’n Bright Manual Del Usuario

6. Operation

EN
• Clean the facial brush before first use as described in
• Before cleansing an area of the face for the first time,
• The LED light

6.1 Using different areas of the facial brush

Area
Cleansing area
(thicker studs)
Cleansing area
(thinner studs)
Massaging area
(ridges)
3

6.2 Operation modes and speed settings

• The facial brush is equipped with a vibrating and a pulsating
mode. Each mode has 7 speed settings.
• The vibrating mode uses uniform vibrations for deep, gentle
cleansing.
• The pulsating mode uses alternating strong and weak
vibrations for a massage-like soothing effect.

6.3 Switching on/off and selecting an operation mode

1. Press the control button ( )
switched on and in the vibrating mode.
You will hear one beep sound when the facial brush is
switched on.
2. Press the control button ( ) again. The facial brush is now in
the pulsating mode.
3. Press the control button ( ) a third time to switch off the
facial brush.
You will hear two beep sounds when the facial brush is
switched off.
13
the chapter "Cleaning".
perform a skin sensitivity test on a spot. Start your
treatment only if there is no adverse reaction.
8
flashes once whenever a button is pressed.
Best for
Precise cleansing and removal of dead skin
cells and horny layers.
1
Gentle cleansing of large areas such as
cheeks.
2
Massaging the skin for improved blood
circulation and promoting the absorption of
skin care products.
is solid white during operation and
once. The facial brush is now
5