Ryobi RLS1351 Manual Del Operador página 11

TO iNSTALL ThE FEET TO ThE SAw BASE
See Figure 6, page 18.
 Align hole in foot with hole in saw base.
 Insert a Phillips screw in the bottom of the foot and into
the base. Tighten securely.
 Repeat for the other three feet.
TO iNSTALL wORK CLAMP
See Figure 7, page 19.
wARNiNg:
In some operations, the work clamp assembly may
interfere with the operation of the blade guard assembly.
Always make sure there is no interference with the blade
guard prior to beginning any cutting operation to reduce
the risk of serious personal injury.
The work clamp provides greater control by clamping the
workpiece to the saw table. Use the work clamp on all non-
rip cuts.
To install the work clamp:
 Hold the attachment bolt in place while unscrewing and
removing the clamp knob.
 Place the work clamp over the attachment bolt and se-
cure in place using the clamp knob.
To use the work clamp:
 With fence mounted to the saw table (see instructions
below), place the workpiece firmly against the fence.
 Rotate the knob on the work clamp to move the clamp
up or down as needed. Do not overtighten.
TO iNSTALL FENCE FOR MAKiNg MiTER /
CROSS CUTS
See Figures 7 - 8, page 19.
 Install the work clamp to the fence. Do not tighten
attachment bolt.
 Place the attachment bolt into the miter groove and
the locator pin (under right side of fence) in the anchor
hole.
 Slide the adjusting clamp along the miter groove until
reaching the desired angle.
 Tighten the clamp knob securely.
ASSEMBLy
TO iNSTALL FENCE FOR MAKiNg RiP CUTS
See Figure 9, page 19.
 Remove the work clamp from the fence. Do not tighten
attachment bolt.
 Place the attachment bolt into the rip groove.
 With the fence parallel to the saw table, place the loca-
tor pin in the right groove of the saw table and the left
side of the fence in the left groove of the saw table.
 Slide the adjusting clamp along the rip groove until
reaching the desired distance for the cut.
 Using the scales on the saw table, check that both the
left and right sides of the fence are the same distance
from the blade so the fence is squared to the blade.
NOTE: If you cannot square the fence to the blade,
contact an authorized service center for assistance.
 Tighten the clamp knob securely.
TO USE ThE DUST BAg
See Figure 10, page 19.
 Slide dust bag onto dust exhaust port.
wARNiNg:
Collected dust from surface coatings such as polyure-
thanes, linseed oil, etc., can self-ignite in the dust bag or
elsewhere and cause fire. To reduce the risk of fire, always
empty the dust bag frequently (10-15 minutes) and never
store or leave the tool without totally emptying its dust
bag. Also follow the recommendations of the coatings
manufacturers.
TO USE wiTh A VACUUM
You can easily attach a vacuum to the saw.
To attach:
 Remove dust bag from saw.
 Attach vacuum hose to dust exhaust port.
wARNiNg:
When not connected to vacuum, always install the dust
bag back on saw. Failure to do so could cause dust or
foreign objects to be thrown into the face or eyes which
could result in possible serious injury.
11