Motor/Tube Assembly; Installing The Tube/Motor Assembly; Wiring - SOMFY PERGOLA io Manual Para El Instalador

3.3. Motor/tube assembly

1) Slide the motor
For smooth roller tubes, position the notch previously cut
on the crown.
2) For safety reasons, fix the roller tube to the drive wheel
with 4 x Ø 5 mm self-tapping screws or 4 x Ø 4.8 mm
steel pop rivets located:
- at least 5 mm from the outer rim of the drive wheel:
L1 - 5, and
- no more than 15 mm from the outer rim of the drive
wheel: L1 - 15.
The screws or pop rivets must only be attached to the
drive wheel and not to the motor.

3.4. Installing the tube/motor assembly

1) Fit the tube/motor assembly to the end bracket (C).
2) Fit the tube/motor assembly to the motor bracket (D).
3) Depending on the type of bracket, position the retaining ring
(E) (for motors 85 Nm with a retaining ring, it is essential
to use the locking retaining ring (F)).

4. WIRING

Always make a loop in the power supply cable to prevent
water entering the motor!
- Cut off the mains power supply.
- Connect the motor according to the information in the
table below:
230 V ~ 50 Hz
1 Brown Live (P)
2 Blue Neutral (N)
3 Yellow/Green Earth ( )
Copyright © 2010 Somfy SAS. All rights reserved.
into the roller
Motor cable
1
tube.
2
1
2
D
3
E
OFF
1
230 V
2
~
3
50 Hz
3 x 1.5 mm
1
2
3
Pergola io
15 mm
5 mm
L1 20 mm
C
F
2
3 x 0.75 mm
2
39