Operating Elements; Conformity And Approval - IMG STAGELINE TXS-606HT Manual De Instrucciones

All operating elements and connections de -
GB
scribed can be found on the fold-out page 3.

1 Operating Elements

1 Display to indicate
1. the channel group (GROUP 00 – 09)
2. the channel (CHANNEL 00 – 99)
3. the microphone sensitivity
(VOL -30 dB, -20 dB, -10 dB, 00 dB)
4. the battery status
full
2 On / off switch
3 Screw sleeve
To access the operating elements (5) to (7) and
the battery compartment on the rear side,
unscrew the sleeve.
4 Threaded ring for the screw sleeve (3)
5 Buttons and
channel number and the microphone sensitivity
6 Button SET: To change the channel group, the
channel number or the microphone sensitivity,
press the button SET repeatedly until the corre-
sponding numerals start flashing on the display
(1). While the numerals keep flashing, make the
settings with the buttons
7 Switch RF for the transmission power
position L: low transmission power (2.5 mW)
position H: high transmission power (25 mW)
8 Sensor for the IR signals for automatic channel
setting
2 Important Notes
The wireless microphone corresponds to all rele-
vant directives of the EU and is therefore marked
with .
G
The microphone is suitable for indoor use only.
Protect it against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the microphone and no
liability for any resulting personal damage or
8
discharged
to set the channel group, the
and .
material damage will be accepted if the micro-
phone is used for other purposes than originally
intended, if it is not correctly operated, or if it is
not repaired in an expert way.
If the microphone is to be put out of opera-
tion definitively, take it to a local recycling
plant for a disposal which is not harmful to
the environment.
3 Applications
To provide a wireless audio transmission system,
combine this dynamic hand-held microphone with
integrated multi-frequency transmitter with the fol-
lowing receivers from "img Stage Line":
TXS-606 with 1 receiver unit
TXS-626 with 2 receiver units
TXS-646 with 4 receiver units
The transmission frequency within the UHF range
672.000 – 696.975 MHz is freely selectable (fre-
quency spacing 25 kHz).
Due to the ACT function (automatic channel tar-
geting), the audio transmission system is very easy
to operate: Simply press a button and, via IR signal,
the wireless microphone is set to the channel
selected on the receiver.

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the wireless microphone TXS-606HT is in ac -
cordance with the basic requirements and the other
relevant regulations of the directive 1999 / 5 / EC.
The declaration of conformity can be found on the
Internet via the MONACOR INTERNATIONAL
home page (www.imgstageline.com).
In the Federal Republic of Germany, a fre-
quency assignment (for which a charge is
payable) is required for the wireless microphone.
The forms and notes concerning the registration of
the transmitters can be found on the Web site of the
Bundesnetzagentur (Federal Network Agency)
under www.bundesnetzagentur.de. In other coun-
tries, it is necessary to apply for a corresponding
approval. Prior to operating the wireless microphone
outside Germany, please contact the MONACOR
subsidiary or the corresponding authorities of the
respective country.