Menu Item 11: "End; (Extinguishing The Adjusting Menu); Remote Control - Monacor security TVCCD-800ECOL Manual De Instrucciones

gering to cancel the procedure with "NO". Then confirm the selec-
tion with the key "SET" (12).
Attention: The function "RESET" will delete all adjustments made
by the user irretrievably and replace them by factory-
set presettings.
The factory-set presettings are comprised in the following table:
Menu Item Presetting
CAMERA ID OFF
BLC OFF
Lens Video/DC – depending on the switch position (6)
Shutter OFF
Gain AGC
Gain Limit: Middle
White Balance ATW
Color AUTO
Color
Color
B/W
BURST: OFF
Sync. INT

8.12 Menu item 11: "End"

(Extinguishing the adjusting menu)

After all necessary changes have been made, the adjusting menu
can be exited via this menu item. For this purpose press the key
"SET" (12) with the menu item selected.
B/W Point: 3
B/W Time: 5
Color Time: 10
9

Remote Control

Via the 3-pole jack "REMOTE" (16) it is possible to make all menu
adjustments via a serial interface. The following configuration
applies to the connection:
As the camera itself does not transmit any
Rx (Receive Data)
data but exclusively receives data, connection
Tx (Transmit Data)
of the centre contact (Tx) is not necessary.
GND (Ground)
REMOTE
The serial interface according to RS-232C has the following trans-
mission parameters:
data rate: 9600 bps
data bits: 8
stop bits: 1
parity: none
The transmission protocol comprises 6 bytes which are distin-
guished in the third byte depending on the function of key:
Function of Key
(Number of the key)
„SET" (12)
(8)
(11)
(9)
(10)
Data Bytes (hexadecimal)
0A, 02, 01, 00, 00, AF
0A, 02, 02, 00, 00, AF
0A, 02, 03, 00, 00, AF
0A, 02, 04, 00, 00, AF
0A, 02, 05, 00, 00, AF
GB
27