Operating Elements And Connections; Safety Notes; Conformity And Approval; Rack Mounting - Monacor TXA-802SR Manual De Instrucciones

2-Channel Multifrequency Receiver
These operating instructions are intended for users
without any specific technical knowledge . Please
read these operating instructions carefully prior
to operating the unit and keep them for later re-
ference . All operating elements and connections
described can be found on page 2 .
1 Operating Elements and
Connections
1 POWER switch for the receiver
2 Controls, one each for receiving unit A and re-
ceiving unit B: to switch the respective receiving
unit on /off and to adjust the volume
3 Display: indicates the transmission channel and
the strength of the radio signal received
(left: receiving unit A; right: receiving unit B)
4 Buttons SET,  and  to make settings; see
chapters 6 .1 .1 to 6 .1 .3
5 Receiving antennas
6 XLR audio output for connection to a balanced
microphone input
7 Audio output via 6 .3 mm jack (unbalanced) for
connection to a line input; use the switch next to
this output to select the output level, depending
on the sensitivity of the line input
8 Switch to select the output level of the 6 .3 mm
jack (see above)
9 Low-voltage jack to connect the power supply
unit provided

2 Safety Notes

The units (receiver and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage . Leave servicing
to skilled personnel only . Inexpert
handling of the unit may result in
electric shock .
•
The units are suitable for indoor use only . Pro-
tect them against dripping water, splash water
and humidity . Admissible ambient temperature
range: 0 – 40 °C .
•
Immediately disconnect the power supply unit
from the mains
.
1 . if the receiver or the power supply unit is vis-
ibly damaged,
2 . if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the unit must be repaired by skilled
personnel .
•
For cleaning only use a dry soft cloth; never use
water or chemicals .
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used
for other purposes than originally intended, if
they are not correctly connected or operated, or
if they are not repaired in an expert way .
If the units are to be put out of operation
definitively, take them to a local recycling
plant for a disposal which is not harmful
to the environment
3 Applications
The multifrequency receiver TXA-802SR works
with 2 × 16 channels in the UHF frequency range
863 – 865 MHz . With two matching transmitters
(e . g . TXA-800HSE, TXA-800HT, ATS-12HT), two
wireless audio transmission paths can be estab-
lished .

3.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the receiver TXA-802SR complies with the
directive 2014 / 53 / EU . The EU declaration of con-
formity is available on request from MONACOR
INTERNATIONAL .
The receiver is generally approved for opera-
tion in EU and EFTA countries .

4 Rack Mounting

With the mounting material supplied, two receivers
TXA-802SR can be inserted into a rack for units
with a width of 482 mm (19") . In the rack, 1 RS
(rack space = 44 .5 mm) is required .
Use two connection plates (one on the upper
side, one on the lower side) to screw the two re-
ceivers together . Screw a mounting bracket onto
the left and right sides of the pair of receivers; then
insert the pair of receivers into the rack by means
of the mounting brackets .
7