Starting Wd-K10Pbs In Transceiver Mode - Kenwood WD-K10PBS Guia Del Usuario

CAUTION
Dust resistant/water resistant and environment of use
●
If the supplied microphone plug mounting bracket is used when
connecting the specified option to the speaker/microphone
terminal, the transceiver meets the IP67 dust resistant/water
resistant specifications. The dust resistant/water resistant
performance of the option vary with each optional product.
If an option other than the above is connected, the transceiver is
not dust resistant/water resistant.

STARTING WD-K10PBS IN TRANSCEIVER MODE

WD-K10PBS can be used as a base unit or sub unit.
To use as a sub unit, perform the following operations and start in
Transceiver Mode.
1 If the unit is turned on, turn off the power by pressing and
holding the [Power] key until the Status LED goes off.
2 While pressing the [PF 1] key, press and hold the [Power] key
for 2 seconds or more.
The unit enters into Transceiver Mode. Voice announcement is being
played and the Status LED blinks in green.
Note:
Once the unit is start in Transceiver Mode (sub unit), it will start in
●
Transceiver Mode the next time simply by turning on the power.
Performing the same operations when in Transceiver Mode (sub unit)
●
changes the unit to Base Station Mode (base unit).
When the unit changes to Base Station Mode (base unit), the voice
announcement is being played and the Status LED blinks in orange.
15