Technical Data; Safety Devices; Safety And Information Signs - Angelo Po 1G1FA0E Manual De Uso

See tables and "Connection chart" at the back of
the manual.
Although the appliance is complete with all safety
devices, during installation and connection addi-
tional devices must be added if necessary to com-
ply with the relevant legal requirements.
The illustration shows the position of the devices.
A)Gas supply tap: for turning the connection to the
gas supply line on and off.
B)Safety thermocouple: cuts out the gas supply if the
flame goes out
C)Safety thermostat: cuts off the electricity supply in
case of overheating.
Caution - warning
Make a daily check that the safety devic-
es are properly installed and in good
working order.
The illustration shows the position of the signs pro-
IT IT
vided.
A)Nameplate with manufacturer and appliance
data.
GB GB
B)General hazard: read the manual carefully before
carrying out any procedure.
DE DE
C)General hazard: when washing the appliance do
not point pressurised water jets at internal parts.
FR FR
D)General hazard: all relevant regulations must be
complied with. "Install in compliance with the rele-
vant regulations and use in well ventilated premises
ES
ES
only".
E)General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of fail-
ure to comply with the installation and commission-
ing instructions".
F) Burn hazard: watch out for hot surfaces.
G)CE marking: indicates that the appliance is compli-
ant with the relevant norms.
H)WEEE symbol: indicates that the appliance is sub-
ject to specific waste disposal regulations.
English

TECHNICAL DATA

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

B
G
A
H
- 6 -
A
C
IDM-39616600300.tif
D F
E
C
IDM-39616600400.tif
B