Cleaning Oven; Checking Gas Pressure; Fault - Angelo Po 1G1FA0E Manual De Uso

To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool.
2 - Turn off the circuit-breaker to disconnect it from
the electrical mains.
3 - Remove the bottom plate (C) and the grid (D)
from the oven and clean them thoroughly.
4 - Clean the inside parts of the oven to remove
any deposits which may impair its operation.
5 - Dry the surfaces and reassemble the compo-
nents.
To carry out this operation,
proceed as follows.
1 - Turn off the gas
supply tap.
2 - Pull off the knob
(A).
3 - Undo the screws
(C) and remove
the control panel
(B).
4 - Undo the screw (D) of
IT IT
the pressure connec-
tion.
5 - Connect the pressure
GB GB
gauge (E) to the pressure test point (F).
6 - Turn the gas supply tap back on.
DE DE
7 - Light all the burners and turn the knobs to the
full flame setting (see page pag. 10), then
FR FR
check that the pressure reading complies with
the values provided in the table at the back of
ES
ES
The appliance has been tested before being put
into service. The information provided below is in-
tended to assist in the identification and correction
of any anomalies and malfunctions which might oc-
cur during use. The user can solve some of these
English

CLEANING OVEN

CHECKING GAS PRESSURE

A
TROUBLESHOOTING
D
C
B
the manual.
8 - Turn off the burners, disconnect the pressure
gauge and return all components to their initial
condition on completion of the operation.

FAULT

problems himself, but for others specific technical
knowledge or skill is required, and so they must
only be carried out by qualified staff with recognised
experience acquired in the specific sector of opera-
tion.
- 14 -
IDM-39616601000.tif
E
C
F
D
6