Domo DO7342TV Manual De Instrucciones página 32

· Mount the heating unit on the top of the stand. Feed the metal pins through the extra
holes in the brackets and use the nuts to fasten them. Aim the heating unit in the desired
position and secure it tightly.
· Caution: the appliance must be mounted such that the on-off switch is on the right-hand
side when facing the appliance and looking at the lamp.
· Caution: the appliance is equipped with a safeguard. The working angle is therefore
restricted to between 13° and 43°. This prevents the unit from being aimed too high or too
low. By installing the metal pins, the heating unit cannot be tilted any further.
· Adjust the stand to the desired height and tighten the screw with the adjustment screw on
the stand.
· There is a cord clamp on the stand. Remove it, pull the cord through, and refasten the
clamp.
WALL MOUNTING
· Mount the 4 brackets to the backside of the heating unit with the screws provided.
· The heating unit must be positioned at least 1.8 m above the ground and at least 0.5 m
away from adjacent walls and ceiling.
· Measure the correct distance for the drill holes and drill the 4 holes in the wall.
· Place the expansion bolts (quick anchors) in the wall. Screw in the nuts of the expansion
bolts and remove the pinions. Mount the other 2 brackets on the expansion bolts. Then
32
DO7342TV